|
Factory configured and
“READY-TO-BATCH”. These units contain everything needed for most
batching and filling applications; no extra buttons, timers or
relays are required.
On-site electrical
installation requirements are minimal and limited to very basic
cable terminations only. These units are pre-wired with clearly
marked terminals for connecting power, feeder and discharge solenoid
wires.
This unit is fully
self-contained with most items mounted on the rear of the box lid
for fitting into new or existing control panels.
Up to 20 materials and 99
stored recipes can be named using six alpha/numeric characters each;
i.e. “CEMENT” is displayed to the operator when entering targets,
not material 1 or SP1.
Full automatic batching can
run a single batch or continuous cycles without operator
intervention. Manual mode can be either “full manual over-ride” or
“sequenced manual” where the operator follows a pre-set sequence to
guarantee batch integrity when the Q.A. printing is used.
The operator can select a
recipe and apply a % increase or decrease in batch size; in the
concrete industry the operator can re-call the required design (1
cubic metre of 40MPA concrete), then enters the number of cubic
metres required (3.7) then starts the batch.
|
